Model WA503 Instruction Sheet
WA503 SINGLE RACK, FRONT–MOUNT ANTENNA CONVERSION KIT
Bracket Installation
2. Connect the supplied antenna cables
to the receiver antenna inputs and
WA503 adapters. See Figure 4.
1. Remove the screws from each side
of the receiver. See Figure 1.
ANTENNA
CABLE
ANTENNA
CABLE
RECEIVER
(TOP VIEW)
RECEIVER
(TOP VIEW)
FRONT
FRONT
FIGURE 1
FIGURE 4
2. Secure the brackets (not supplied
3. Screw the antennas into the bulk-
head adaptors protruding through
the front panel. See Figure 5.
with the WA503 kit) to the sides of
the receiver with the screws re-
moved in Step 1. See Figure 2.
RECEIVER
(TOP VIEW)
RECEIVER
(TOP VIEW)
FRONT
BRACKET
BRACKET
FIGURE 2
FRONT
NOTE: There are four holes in each
bracket. Use the rear holes if the re-
ceiver is to be recessed; use the front
holes to mount it flush to the rack.
ANTENNA
ANTENNA
FIGURE 5
4. Insert the receiver into the equip-
ment rack and secure the brackets
to the rack with the supplied screws.
See Figure 6.
WA503 Adapter & Cable Installation
1. Insert the WA503 adapters through
the holes in each bracket, and se-
cure them from each side, using the
attaching hardware. See Figure 3.
EQUIPMENT RACK
RECEIVER
(TOP VIEW)
WA503
ADAPTER
WA503
ADAPTER
FIGURE 6
NOTE: For more information, call
Shure Customer Service at
1–847–600–2000.
FRONT
FIGURE 3
©2006, Shure Incorporated
27B8445 (Rev. 3)
Printed U.S.A.
|